Bulk Solids Heat Exchanger
Category :
Keywords: Pengbo Biotechnology
Urea pellets enter the feed silo from the top, and after being evenly distributed in the feed silo, they enter the plate group for heat transfer.
The urea pellets after heat transfer flow from the long cutting cone to the frequency conversion belt, and the material discharge is controlled by the frequency conversion of the belt speed.
During the entire heat transfer process, the flow of urea pellets is completely driven by gravity and forms a dense phase transport.The top material level radar monitors the material level signal, and the discharge device controls the discharge rate to adjust the height of the material in the feed warehouse to ensure.
Keep the entire plate group always filled with material to achieve the best heat transfer effect. A small amount of cold and dry air will be introduced into the cooler.The right amount of cold and dry air can improve the fluidity of the material, and it can well prevent the risk of bypass and condensation inside the equipment.
Why So Many Factories Install the Indirect Plate Heat Exchanger for Bulk Solids?
1. Lower the packing temperature below 40℃, solving the caking problem.
2. Reduce energy consumption and emission.
3. Compact design with simple system.
4. Easy to install with small installed space.
5. Increase plant competitiveness.
6. Low maintenance cost.
R&D EQUIPMENT
Factory workshop
Factory workshop
Factory workshop
Factory workshop
Factory workshop
Factory workshop
Factory workshop
Factory workshop
Factory workshop
Factory workshop
Factory workshop
Factory workshop
RELATED PRODUCTS
Intelligent Greenhouse is an agricultural facility that applies an intelligent control system to greenhouse planting.
Intelligent coating test device for granular fertilizer
The seasonal utilization rate of traditional fertilizers, nitrogen fertilizer, is only 30%-35%, phosphorus fertilizer is less than 20%, and potash fertilizer is 40%-50%, which causes serious waste of resources and environmental pollution.
Adopt a low-speed gear metering pump with high temperature resistance and high pressure resistance (10 MPa) to ensure accurate metering accuracy (±0.5%)
Urea pellets enter the feed silo from the top, and after being evenly distributed in the feed silo, they enter the plate group for heat transfer.
Compound fertilizer production line
Mixing and crushing: This step is mainly to mix the raw materials and break the large pieces of the raw materials.
ZNC Seed Dressing Special Product
This product is derived from the extract of specific plant endophyte strains.
ZNC Crop Health Special Product
This product is derived from the extract of specific plant endophyte strains.
It has an excellent ability to promote rooting and tillering,which promotes the growth of the mainroots and lateral roots.
It has good growth-promoting and stress-resistance ability,which can significantly improve theability of crops to resist abiotic stress;
Increases crop SPAD value and the net photosynthetic rate,promotes crop growth and development;
ZNC Antibacterial Specific Product
This product is an endophytic fungal extract from wild plants, which can significantly improve the resistance of plants to bacterial diseases.
Methylcarbolinic Acid can effectively regulate plant growth and development, improve cropyield and quality
GET A FREE QUOTE
CONTACT US
Add : No. 1, Beitianmen Street, Tai'an Hi-tech Zone, Shandong Province
GET A FREE QUOTE
Copyright 2025 : Shandong Pengbo Biotechnology Co., Ltd. Powered by：CEglobal SEO BUSINESS LICENSE
